Macrosystem Columbus Manuale Utente Scaricare il pdf (Pagina 27)

head.

Next, open the “Timing” menu, set the “Route”

slider control to 4 seconds and view the “Pre-

view”. Afterwards, open the “Global settings”

menu by rst setting the top selection button to

“Line type” in order to make changes, if neces-

sary, to the line (e.g. type, width, color).

Now open the “Look” menu and activate the

starting point (which you can still recognize by

its ag). Set the top selection button to “Object”

and set the “Object” button to “Off”. Proceed

in the same way with the nishing point so that

neither of the two points has an object (ag)

displayed.

Now open the “Global settings” menu and set

the top button to “Head object”. Then activate

the “Show head object” button so that a little

check mark appears and causes the remaining

buttons in this menu to become activated. Next,

click on the “Select head object” button and

select the “Right hand” from the 3D objects.

After conrming with “Ok”, you can make the

system calculate your scene - and that‘s it!

1 2 ... 22 23 24 25 26 27 28 29 30

Nessun commento

Macrosystem Columbus Manuale Utente Pagina 27